VI should have a spare one if you'd want it sent
Vyes ill send a photo one moment
Vthat said im based in aus so may be cheaper all round to get one from them hahah
WVKB FSC Europe
V
Wdo you have a caliper? Some dimensions would be helpful 
VNo, I do have a tape measure to hand. but im geussing you'd need to it be rather accurate
WGive me a rough measurement of the diameter of the plug part
Vwill do one moment
Wand the threads diameter on the male part
Waliexpress.com
Smarter Shopping, Better Living! Aliexpress.com
V14.5mm Thread Diameter
V9
Vmm
W@vulkan607 perhaps you have a multimeter ? 
One missing piece of information is the pinout from the VKB grip contact PCB -> 4 wire connector mapping. That could be found out with continuity test.
One missing piece of information is the pinout from the VKB grip contact PCB -> 4 wire connector mapping. That could be found out with continuity test.Wah, nvm, found it!
W
TI'm excited by this VKB progress, I better start saving up.
VIndeed, I was ready to switch to a TM grip if It meant using this base
Vbut now I dont have to im very happy
WThe only downside is the dangling wire that will go out of the adapter base
TAre the base and the grip seen as two different controllers?
Wfor VKB - yes
WVKB decided to encrypt the communication with the Grip
TSo you could put one of those cable fittings in the base for the VKB blackbox, then the wire would be inside the base?
BThat's a radio mike connector - still, it's not a bad solution at all, I use them myself on my projects sometimes - poor person's Amphenol 
- still, it's not a bad solution at all, I use them myself on my projects sometimes - poor person's Amphenol 
JI am a bit confused. On the connection diagram the PSU is connected to MOT1 and Motor 2 to PWR. Is this correct?
The motor wires are blue and yellow. Which wire is + and which -?
The motor wires are blue and yellow. Which wire is + and which -?
Wah, it doesn't matter, but thanks for noticing. The power is distributed equally to those 3 ports.
Wpositive is the yellow wire
W
Wprototyping the VKB adapter
OThat looks really good.
W
WAnd voila - real deal 
F
Fhow does the vpforce compare to the Brenner? I have no idea what the Brenner's internals are
SLook up the conversation, there's a review as well about it too comparing both pros and cons
FIs that mine?
WI'm making some in advance
WBut yes, you can say that
F
VDude the CNCed adaptor mount looks so good. It's crazy how low the price you charge for them is.
WI think I'll go with 25€ final price if bought with the rhino, they require a bit of work, but very reasonable price for CNCed composite part.
Nis the design still with a seperate connection or did you reach an understanding with either VKB or their connection?
SSo if you go the vkb route you'll need the grip, Blackbox and electronics too? So basically everything but the gimbal And it'll run on the exterior of the stick.
SAttention to this folks
SSo anybody who wants to use with VKB grip will need to hook separately with a blackbox
PAre there any commercially available desk mounts that would accommodate a Rhino unit well?
KJust found this randomly browsing YT. Seems like a super cool project. How will it integrate with DCS? Does this face the same problems that Brunner has with only reading certain parameters from a lua or will this access all the data from all the modules?