Matze
RRCRat Rig Community [Unofficial]
•Created by Matze on 3/29/2025 in #fix-my-print
Holes in Infill
It was a mixture of overcooling and too high printspeeds. Regular (not High Speed PLA) is hard to dial in. had to lower speeds to 80-100 to get some good results here. Cooling at max is 30% (part cooler is too STRONK! )
11 replies
RRCRat Rig Community [Unofficial]
•Created by Matze on 3/29/2025 in #fix-my-print
Holes in Infill
Not yet, will try later. But i guess i am just trying to print too fast.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Matze on 3/29/2025 in #fix-my-print
Holes in Infill
Anyone has some solid printing settings for PLA to start with? I think my settings maybe a bit off for what PLA actually needs
11 replies
RRCRat Rig Community [Unofficial]
•Created by Matze on 3/29/2025 in #fix-my-print
Holes in Infill
Maybe 300 mm/s is too much for printing infill in PLA. Reduced to 250 and trying again.
11 replies