sjscymru
RRCRat Rig Community [Unofficial]
•Created by sjscymru on 5/18/2025 in #fix-my-printer
MCU Shutdown in Performance Mode (Rescheduled Timer in the past)
Hi. Do you mean the CM4? It has a heat sink installed on it. And I have the 3 fans in the electronics enclosure fitted and they are running so there is some active cooling for the controller board.
I seemed to have potentially resolved the issue by reducing the number of microsteps for the motors from 64 to 32. Perhaps the controller clock speed is too low to handle 64? AFAIK the octopus is clocked at 160MHz, whereas the Manta M8P v1.1 is only 64Mhz.
5 replies
RRCRat Rig Community [Unofficial]
•Created by sjscymru on 5/16/2025 in #fix-my-printer
Can't detect DFU on EBB 42 Toolboard
I managed to resolve this by performing a fresh configuration using the wizard.
4 replies