hardware-help
coding-help
official-product-help
project-showcase
general-help
pcb-help
adafruit-help
official-product-help
robotics-help
sensors-help
coding-help
hardware-help
esp-help
pi-help
i2c-serial-help
Schottky Issues: how does it work?
Hey All.
I need some help due to my lack of understanding.
I am planing a power supply für my esp32 devkit project....
New sensor BMV080 on Shuttle Board 3.1
Looking for someone who had touched the new BMV080 particulate matter sensor, especially with Shuttle board 3.1 .
I'm Struggling of making the Shuttle Board 3.1 on which is installed the BMV080 sensor to work with ESP32....
GY-BN008X with Arduino Mega 2560 Wiring Issues - Unable to detect device with I2C
I have tried to wire this as per help with some forums and ChatGPT and it doesn’t seem to be working… I am trying to use the I2C scanner to find the device and am unable to. Looking for feedback and direction here, this is my first project.
Motor and esc have power, cant control them
motor beeps when plugged in but nothing after, no movement at all. any and all help appreciated. Motor doesnt turn. motor beeps when powered. Im just trying to get it to spin at all and nothings happening. it will be apart of a drone and will have others connected similarly but not even this one works. Both esc and motor were purchased on amazon and do not provide datasheets. The ESC's brand is aneegfpv, it is a 40a max ESC with 2-6s input which is in range of our lipo. The motor is CENPEK A2212 1000KV Brushless Motor 13T. multiple variations of code has been tried.
Codes:
#include <Servo.h>...
Upgradable connections?
I have a circuit board of an rc plane, which i had to open (of course). I want to not only put it back, but also be able to remove the connections and test them on a breadboard or something similar.
The circuit board is unlabelled, but i know what everything does. There are two motors, a battery connector and two LED's connected to the same + & -. Images are attached.
If there nothing such, what are those battery connectors called?...
DHT11 Humidity sensor not reading.
I am using a keyestudio DHT11 humidity sensor. I have checked the wiring multiple times, so I think it is correct. The error that it gives me switches randomly between 16,12 and 16,16. I have attached a photo of the arduino and where the wires are connected.
Joystick buggy with ESP32
Hello. I uploaded a simple code to read joystick values to my ESP32 but the values aren’t reading the usual 0-1023 and instead are lying between 0-4095 with the values constantly fluctuating even when centered. I assume it has something to do with the hardware and connections messing with the signal but just in case I’ll show the code too
Trying to get nrf905 to work
Hi everyone, i am trying to make my nrf905 work with an esp32s3, but i am starting to give up…
I tried a lot of different ways, trying all the available libs with exemples, notions worked.
for exemple the Radiohead library shows that the modules are correctly initialized, but no communication happens, even on my sdr i cant see any communication....
