why did you have to re-orient your rhino base when you attached the z-extension? In order to have the stick as close as possible to my seat, I was planning to mount the rhino with the buttons forward and invert the axes.
For me, with the Z extension, it was TOO far back as you describe. Z extension and buttons nearest me works perfectly now. Of course, your set up may be different, I have limited space in front due to my centre MPCD
when using a Virpil grip with the Rhino base, I'm assuming that the Virpil software can no longer be used to customize the grip? With the Virpil software I created button presses at the end of the travel on each axis on the thumb stick, so that it can also work as a hat. Will I lose this functionality when connecting to the Rhino?
hey @walmis, maybe my previous was lost somewhere so here goes again: Thanks for accepting the order. Am I correct in thinking I should get a message with the invoice + istructions for the payment?
Hello, I am thinking about moding my rhino to make it quieter and cooler by using a permanantly running 140mm fan to cool it. Would it be possible to have this fan externaly mounted with a pipe to get the air from it to the case? Ideally making it going by the side under the stop button and the potentiometer
Or fly extended periods of time without trimming. I showed my parents and brother my setup a few days ago, they did not use trim and constantly countered the stick instead. That's like the first time i've heard the fans. Otherwise i only hear it in WW2 dogfights
Is the native FFB profile for the F5E rather weak, or is it just me? Idk if it is supposed to be that light (even with hydraulics). I can pull 8gs with fingertip pressure
The F-16 being weird in ffb kind of makes sense though, especially the elevator axis being soft. The sim version we have is taking simulated FSSB controls, and meshing them in to traditional spring feel to give some sense of that (the elevator being softer than the ailerons), then trying to translate that in to FFB. Something is bound to get lost in translation/feel weird. Especially compared to non-FCS jets.
Your Rhino had a pre-release firmware loaded that fixed the mentioned issues on the new board revision. I'll release v1.0.16 today, so should be all good afterwards.
Thank you, also before I updated the firmware, I selected my VPC Alpha as the connected grip and it caused the stick to start oscillating back and forth.