Nedge seems to ignore that (I have it disabled)
Aoh sick, will def shut this off in chrome
Ai'll try both of these! much appreciated!
Adoing this in chrome and edge appears to have fixed the problem! thanks!
Shi, with the new version and after testing, the engine rumble makes the rhino rumble a lot making it disconnect the X axis as before. but I noticed that if I cut the engine the effect goes away in the TelemFFB but the rhino keeps rumble. any idea? I'll turn it down at low RPM and check. if not I have to turn it off for now
Nit is unlikely that any of the rumble effects are causing your axes to go into protection mode and disconnect. If your screenshot above 🧰support is still accurate, you have the "Periodic Effects LPF" set to 0Hz.. I can't give you a technical explanation, but I can tell you that that will not play nicely with the effects in TelemFFB. The default is 20Hz I believe
WOh yea, didn't notice that! 0Hz on periodic will definitely cause problems, set it to 20Hz @snooperoldschool
Sok, if I changed it it was by mistake because I dont recall messing with that!!!
SI'm positive sure that I didn't change that!
Sthanks!
WNo prob, maybe a firmware update caused it, who knows 
Sthats was the culprit, problem solved, now i runs like a kitten, so much I need to put more intensity in the low rpm rumble lol
Sbut I have something here
Sif I cut the engine I get all rumbling again until it disconnects.
SIf I set engine_rumble_lowrpm_intensity = 0.2 after cut the engine have the same behavior .
Ncut the engine on the ground or cut the engine in the air?
Sall in the ground
Sand the only thing that solves it is disconnect and connect again
Sthe behavior dont shows at 0.1
SI have to do more testing, i'll report back.
Nwhat is your
engine_rumble_lowrpm setting? The effect follows the prop RPM... so if the prop is stopped, the effect should stopSit happened at 0.2
Sand actually after the engine cut the effects go out in the app but the rhino keeps shaking
Si'll make a video , its better to see it instead of write it up, because it looks something more is happening in the background.
WDoes the telemFFB log indicate any errors? Sounds like USB could be picking up interference or smth.
Sthe only error is after some seconds the beep and the X axis disconnect with that previous error.
Wahh, try reducing the the LPF from 20Hz to 15Hz
Sits like its getting stronger with each start I do
SMotor X: FAULT_UNEXPECTED_D_CURRENT
S
Schanging from 20 to 15hz look that helped somehow but just to mitigate it
Swhat I'm doing is start the engine and stop it several times
Si'll record it
WWhat happens here when you do it?
Swhere is that?
WDebug tab
Sone sec
S
Sfirst start
Wcan you scroll loaded effects to the bottom?
Salready heppned it disconnected the X
S
Sand with it working
Sits the video I did
SI can upload it another way
Sengine rumble at 0.15 I can't make it happen
N- What is your
engine_rumble_lowrpm? Did you modify it from the default 650? - Does the effect stop (when its 'stuck) if you pause the sim?
SRecord you and your screen to clarify your points. Get vidoes organized as mind map, calendar, or any layout. And share it with a link to boost your productivity.
SI set it to 0.2 max, and at that setting that happens in the video