I plan to invert my racing pedals and raise them higher than they currently are (I have rudder pedals mounted on a frame I added to the bottom of my cockpit underneath the racing pedals, then I just slide the racing pedal plate backwards to use them) so that I have access to both at once, but since it is entirely DIY with no real reference I'll basically need to get every part cut to custom lengths and figure out every piece I need.
I also plan to modify left cockpit arm that will mount my throttle and control panel into a door so I can open and close that for easier access to sitting down.
Lastly, I plan to diy some sort of floor shroud around my center mounted Rhino base so I don't accidently hit it with my shoes getting in and out
J
B
D
N
F
M
faq
S
H
V
V
RHINO #0320 Has Shipped!
D
L
? I know, it looks too small to be stable but I don't see any other way to mount a Rhino into this rig right away. Not without making several new parts out of wood or metal.
T
S
fairly accurate numbers.
D
P
D
RHINO #0321 Has Shipped!
hmm it finally updated on tracking, but the email suggests delivery on Friday the 22/12. I doubt that will work out for them.
A
W
J
). But if you can lower the round plate low enough, I'd try attaching base plate to that first 
