Hey... this just happened in DCS Tomcat... stick just went full berserk forward and the weight of the Warthog stick on Virpil extension tore the thread in half... I am putting my log and config if someone can check if ther is anything wrong.... I did not really change anything to DCS profiles... maybe just created a couple MSFS profiles...
Hi @walmis just popped in an order form for the winwing adapter, the one I was using, the plastic screw on part that attaches to the base snapped in half and the joystick fell off. The adapter on the left is the one that broke, the one on the right was the original I ordered but it never worked. Just tried it again but it wouldn’t connect correctly in that the flight controls worked, but the functions on the joystick would not work such as the gun trigger or any other buttons. Might it have something to do with the metal surround under the arrow around the pins? The broken one doesn’t have one and all functions worked normally……just a thought. Cheers.
Oh well I’m not 100% sure, I just know that was my problem with mine not working. Now that I think about it though, you do have a point. Still worth it to check. Gets you back in the seat quicker.
I got a lib usb transfer error, I think from telemffb while trying to fly in msfs and now my stick won't turn on and windows says device not recognized when I unplug/replug
That error isn't from TelemFFB, its actually from Configurator (occurring when TelemFFB uses the CLI to load the profile).
Suggests a USB error, commonly caused by overloaded or misbehaving USB hub. If its connected to a powered hub, try power cycling the hub, or try plugging directly into the PC
Have you switched between Rio and pilot seat by chance? There's a known issue where the Ai moves the trim to the extreme while you sit in the aft cockpit. Makes a wild ride when you go back to pilot seat.
Hello guys im having some issues with ny rhino i tried to install the throw limiter and after installing the piece and hitting auto calibrate in the software im Getting this behavior
Did you just hit calibrate or did you actually do the calibration? Auto doesn't mean you don't need to do anything. I assume the axis values are bogus.
Did you apply/store settings? There could also be some mechanical flex in the assembly which can be tuned out with the numbers to the right of the axis limit values.
Minor issue - the red power button base loosened up. I assume I just remove the screws in the top panel, lift it up and I should be able to tighten the button. Are there any tips or a better way to do this?
I think while I have it apart, I’m going to look at the possibility of moving the adjustment dial - it’s too close to the power button for my big fingers. Again, any tips?
I'm convinced there is something wrong with my x axis motor or it's sensor or maybe it's my settings but it is almost constantly cutting out with telemffb effects & even without that running when flying in IL2. Any ideas on how I can test this? Happy to post my settings if someone would be willing to check them out & test them. Any help would be great thanks.
without telemffb running the native ffb effects from IL2 will cause the x axis to do it's 'safety-cut-out'. It happens the worse in DCS with telemffb & heli effects like ETL VRS etc. it's never the y axis only the x axis.
I see. I thought you meant it was cutting in and out like stopping/starting.
If the axis is going into failsafe cutout, there's likely something in your settings that is leading to the instability. For me, this usually happens if I get too aggressive with combinations of damper/friction/inertia. Could also be something in your "expert settings".
Post your configurator settings, both the "settings" and "effects" tabs. Maybe something will jump out or maybe walmis will have a suggestion.
M
T
P
W
*
A
J
K
V
L
N
M
W
H
V
B
