After about three months of using my rhino with a thrustmaster warthog grip the buttons stopped work
After about three months of using my rhino with a thrustmaster warthog grip the buttons stopped working mid flight , I was trimming f18 and it just went more and more nose down trim.
In the rhino config app it showed button 14 permanently on which I think was nose down trim.
when I unplugged the grip and replugged back in no buttons show up on app.
Debug shows all FFFFFFFF which I think is gripping not detected,
I had swapped my 3d printed grip adaptor for a metal one about a week before so I removed it and saw that the green wire (clock) was cut but still continuity to the Wallis board.
But to rule this out I rewired the din plug and check continuity against the attatched drawing .
Still no buttons
I replaced grip with a new thrustmaster f-18 grip but still no joy
Have I brick the walmis board and can someone confirm that the drawing attatched is the correct wiring.
In the rhino config app it showed button 14 permanently on which I think was nose down trim.
when I unplugged the grip and replugged back in no buttons show up on app.
Debug shows all FFFFFFFF which I think is gripping not detected,
I had swapped my 3d printed grip adaptor for a metal one about a week before so I removed it and saw that the green wire (clock) was cut but still continuity to the Wallis board.
But to rule this out I rewired the din plug and check continuity against the attatched drawing .
Still no buttons
I replaced grip with a new thrustmaster f-18 grip but still no joy
Have I brick the walmis board and can someone confirm that the drawing attatched is the correct wiring.
