One more idea for increasing actuation forces on diy 4-ways is screwing the base of the hat-shaft t
One more idea for increasing actuation forces on diy 4-ways is screwing the base of the hat-shaft to a flexural plate at the bottom of the housing similar to a force sensing stick base. Actuation force could be tailored by using thicker/thinner flexural plates to combine with the switch force. Would probably need a metal stem at that point but likely some long/thin standoffs could be used as shafts, like M1 size or something? Found M1.6x30mm (3mm od) which seems like it might be just right
