Agit68
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 4/12/2025 in #fix-my-print
Bad/weak prints
Can I recommend a food dehydrator? I've been using one for about a year now and it's adjustable enough to fit a variety of spool sizes. With an indicator card it gets the filament to <10%
I'm using a cosari that I cut the inner rings out of:
https://www.amazon.com/COSORI-Dehydrator-Temperature-Overheat-Protection/dp/B09GFVL7QX
I typically go for 24h at 130F for petg.
DO NOT USE THIS FOR FOOD AFTER FILAMENT!
20 replies
RRCRat Rig Community [Unofficial]
•Created by IamSnah on 12/19/2024 in #fix-my-printer
Idex upgrade, "ADC out of range" - is there something wrong with my Rapido?
Thank you this helped my issue!
8 replies
RRCRat Rig Community [Unofficial]
•Created by Agit68 on 3/9/2024 in #fix-my-printer
New Build V-Core300 Y homing goes toward the front with endstop switches
Solved!
I mixed up Left & Right stepper leads on the board, I swapped them and all is functioning properly,
4 replies
RRCRat Rig Community [Unofficial]
•Created by Agit68 on 3/9/2024 in #fix-my-printer
New Build V-Core300 Y homing goes toward the front with endstop switches
4 replies
RRCRat Rig Community [Unofficial]
•Created by Agit68 on 3/3/2024 in #fix-my-printer
New build, PT1000 showing incorrect temp.
That worked! Thanks again, I will mark this as solved
6 replies
RRCRat Rig Community [Unofficial]
•Created by Agit68 on 3/3/2024 in #fix-my-printer
New build, PT1000 showing incorrect temp.
Thanks!
6 replies
RRCRat Rig Community [Unofficial]
•Created by Agit68 on 3/3/2024 in #fix-my-printer
New build, PT1000 showing incorrect temp.
6 replies