cdorety
RRCRat Rig Community [Unofficial]
•Created by cdorety on 4/21/2025 in #fix-my-printer
RatRig v4 500mm electronics/controller fan weird behavior
It is set to 24 and was working properly for a while
6 replies
RRCRat Rig Community [Unofficial]
•Created by cdorety on 4/21/2025 in #fix-my-printer
RatRig v4 500mm electronics/controller fan weird behavior
You think its a component issue on PD12, like the tiny FET? If so I'll keep a close watch on PD13. If PD13 fails in the same way I'll just hook the fan directly to the 24v power supply so it's always on if the printer has power.
6 replies
RRCRat Rig Community [Unofficial]
•Created by ChatGPT-anon-bot on 4/20/2025 in #fix-my-print
Using V-core 4 hybrid, have problems with my prints
could be wet filament? or just bad filament. I had a spool of hatchbox PLA that turned out to just be completely unusable. My prints either failed, or looked similar to what you have there.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Katteker on 4/9/2025 in #fix-my-mesh
VC500Idex bad mesh
I spent a few hours last night reading through other bed mesh threads here and making minor adjustments to the machine frame. My best scan was 0.165mm but it seems, now, to average around 0.21mm. I'm sure it will change again when I add the enclosure panels.
10 replies
RRCRat Rig Community [Unofficial]
•Created by Katteker on 4/9/2025 in #fix-my-mesh
VC500Idex bad mesh
I had a very similar looking initial mesh. Also did not do the initial calibration before the magnetic surface. I wish I could say it was because I got it used.....nope....just skipped a step. Anyhow, I am about to start tweaking the frame. Any tips? Were you able to get a better mesh? if so can you talk about how? thank you
10 replies
RRCRat Rig Community [Unofficial]
•Created by cdorety on 4/8/2025 in #fix-my-printer
Dumb question? Or I'm totally missing something. Commissioning Hybrid XY
Solution: seems to be just finding the correct lines to ! invert. Took some trial and error, but I got it. On to the next step
5 replies
RRCRat Rig Community [Unofficial]
•Created by guesswhatsthisparlor on 2/17/2025 in #fix-my-printer
X stopped working when changing to Hybrid
"guesswhatsthisparlor
OP
— 3/19/25, 3:02 PM
TLDR: When moving to hybrid mode in the Configurator, it swapped X1 and Y
Well, thanks for the help guys:ratrig_heart:" ----- I read this whole thread for that??!! 😉 jk, But now I know something else to look out for when commissioning my build next week.
461 replies