Thundersh0ck
RRCRat Rig Community [Unofficial]
•Created by NebuCHADnezzar on 4/3/2025 in #fix-my-print
Unknown printing Artifact PLS HELP!
if you havent found it already theres 2 setting in orca slicer that i feel should be off by default that can cause dragging, in the OTHER tab uncheck reduce infill retraction and personally one i find thats more trouble than its worth in STRENGTH uncheck infill combination. with no retraction can generally lead to no z hop (I use .3 for the record on Z). Also in your printer settings under extruder youll see Z above and Z below Just set them both to 0 and you can tune them out later if you wish
2 replies
RRCRat Rig Community [Unofficial]
•Created by Thundersh0ck on 4/1/2025 in #fix-my-printer
Bad stepper motor?
I'll give that way a try today when the motor gets delivered thanks!
6 replies
RRCRat Rig Community [Unofficial]
•Created by Thundersh0ck on 4/1/2025 in #fix-my-printer
Bad stepper motor?
2.7 on pfmakes belt tensioner which netted 55.2 and 55.4 hz for the belts I didn't think it was excessive but it may have been too much? Do you think the belts could have been damaged as well?
6 replies
RRCRat Rig Community [Unofficial]
•Created by Thundersh0ck on 3/19/2025 in #fix-my-printer
Beacon contact not being used for bed mesh when enabled
Thank you so much! im new to klipper so its been a learning experience!
10 replies
RRCRat Rig Community [Unofficial]
•Created by Thundersh0ck on 3/19/2025 in #fix-my-printer
Beacon contact not being used for bed mesh when enabled
Oddly enough if i do BED_MESH_CALIBRATE PROFILE="default" PROBE_METHOD=contact it will contact as it should for the bed mesh
10 replies
RRCRat Rig Community [Unofficial]
•Created by Thundersh0ck on 3/19/2025 in #fix-my-printer
Beacon contact not being used for bed mesh when enabled
Here the print config everything else is stock idex 400 settings
10 replies