t8k3n
RRCRat Rig Community [Unofficial]
•Created by t8k3n on 5/17/2025 in #ratos-support
Z-tilt configuration
When working on running the Pressure Advance config print. The x and y and z homes ok but when it starts the z-tilt calibration, it errors when it goes to the back left corner for being unable to see the probe. The reason why is, it has dropped the back motor down so the probe can't see the bed. I've reset the bed position a couple of times with the same result. What do I adjust to get it to not drop the back z motor down?
71 replies
RRCRat Rig Community [Unofficial]
•Created by t8k3n on 5/9/2025 in #ratos-support
Configure new Hybrid 3.1
I powered up the v3 for the first time and made it to the homing checks. It homed to the back but went the wrong way to home the X axis. I have it configured as hybrid but everything I've read says to get it working without the hybrid belts first. Do I need to change the configuration to coreXY first then change it to Hybrid after I make it to that point? I was thinking that would undo any changes I have to make to get it working.
33 replies