Need advise on how to fix this mesh
So I think I am almost there with my mesh. There is this bow upwards in the front. I redid my gantry rail, but I guess that was not the problem. Anyone have any ideas? is it a frame problem?
Bed or frame?
Does this look like a frame or a bed issue? It's a 330x330 5mm aluminium bed with a textured PEI magnetic surface. It looked fairly straight until I had to replace the heater. Measured with a SuperPINDA.
V-Core 3 Mesh Problem
Hi,
maybe someone here has a tip for me my bed mesh is very crooked i watched the video on youtube which is the best thing to do
for me, point C is way too high, so I pushed point B down as far as I could...
Clarifications about Frame Squaring Video?
I'm looking at squaring up a V-Core 3 400mm frame that is about .65mm out of square, and I'd like to double check a few things about 3d Printers & a Whiteboard's video about squaring (https://www.youtube.com/watch?v=h7ZTq2dDTkM)
It sounds like for just a tilted bed mesh, the A/B points (the X axis in the front) is generally always going to have the actual corners defining one plane (since this is where the two points of the bed triangle are?)
It sounds like corners D and C are hard to adjust, so generally you're just adjusting the Bar [AD] and Bar [BC], except we do it on the A/B ends of the bar due to D and C....
