O
F
3
N
33
FFN
TFF
T
T
When I was running TelemFFB for the first time in months was when it tried killing itself with instant up/left as I was spawning in, never had that happen before.N
Effects tab is configured (since the settings sliders are factors of the effects tab values), those Damper/Inertia/Friction sliders are insanely high and will absolutely lead to instability and potential motor fault protection shutdowns, especially when there are effects like engine rumble and or elevator droop suddenly playing when you load into an aircraft.T
WTT
MNW
Maybe some paragraphs would be nice.W
After recalibrating everything and reversing the x-axis, Rhino is functioning much better now. However, there's still an issue with the AH64 and force trim that needs addressing. Essentially, upon starting up the AH64 (with all settings in the configurator set to default, I believe), my stick tends to drift down. When I press the force trim button, it does shift to the new center, both visually in the stick monitors (both in DCS and the one in the configurator). However, the stick still feels somewhat limp, like it has a low spring value, despite the spring being set at 100% in the main settings. Additionally, it continues to drift. Strangely, when I hit reset FFB effects (in telem), the stick firms up and behaves as expected. However, after doing this, when I hit force trim, the center shifts in the DCS stick monitor but remains unchanged in the configuration monitor, and the stick does not shift to the new center as it did before the FFB reset.
Apart from the force trim issue, the stick behaves as expected. Interestingly, when I check the debug page in the configurator (before the FFB reset), loaded effects IDs 1-4 look normal. However, at ID5, there's a spring entry showing 9%, with a center of 0, coefficient of 4055, and saturation of 4096. Immediately after the FFB reset, I get the loaded effects 1-4 as before, but now with ID5 showing "SINE" next to it, along with "100%" next to all other IDs except ID5, which oddly displays "SINE" with "9%" next to it, resembling the pre-FFB reset state.
Following the FFB reset, the trim reset no longer seems to function on the stick or reflect in the configurator monitor. Any assistance in resolving this issue would be greatly appreciated. (I can also provide some screenshots of the settings if needed).
WWWW
M
-so to address some of the points 1)so can check the trim settings in DCs (assume I should make them match the screenshot for the rhino column?)2)in terms of testing without Telem I can try (assume the force trim function should function with telem off- restring the position of the stick?)3)correct using the f18 metal stick with a Z extension - what would u suggest for the balance spring settings?4)will post some setting pics shortly?5) note your points on resetting FFB (found I did not need to restart DCs after resetting - only issue was the force trim not working - but restart if I do in the future) 6)assuming from the comments the id5 spring setting appearing set to 9% then after a reset appearing as a sine also at 9% could be a red herring?W
IMM
W
V
WV
WWWWWW
V
DD
D
PF
BN
Effects