metal_mp
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 5/1/2025 in #ratos-support
Tangle / clog detection on/off?
Ok, after doing some digging I now know I need to change the following:
[gcode_macro T0]
variable_enable_clog_detection: True ---> False
How can I do this in the start gcode in the slicer? I tried adding the following (which did not work):
T0 variable_enable_clog_detection: False
3 replies
RRCRat Rig Community [Unofficial]
•Created by lingo124 on 4/5/2025 in #fix-my-resonance
Vcore4 IDEX 400 t1_y Resonance Graph Wildly Different
I'm having the exact same problem on X: one peak around 50hz and one around 37hz. I just can't find the cause of the 37hz one... Did you figure it out already?
2 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 3/13/2025 in #fix-my-printer
Squeeky timing pulley
No squeeky noises so far! 😃
12 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 3/13/2025 in #fix-my-printer
Squeeky timing pulley
Thanks for the prompt response btw @TheTik
12 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 3/13/2025 in #fix-my-printer
Squeeky timing pulley
None of the 4 moters had the set screw against the flat, so I redid all of them. It really makes sense to do it like this of course, but since this isn't mentioned in the guide I figured all would be well (and it mostly was).
12 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 3/13/2025 in #fix-my-printer
Squeeky timing pulley
It seems that might be the problem indeed
12 replies
RRCRat Rig Community [Unofficial]
•Created by metal_mp on 1/21/2025 in #fix-my-resonance
Belt Tension check V-Core 4 400
2 replies