Hercules_119
RRCRat Rig Community [Unofficial]
•Created by Hercules_119 on 4/29/2025 in #fix-my-printer
Upper belt binding.
Update on this. I have installed ceramic bearings and toothed idlers. It no longer binds when moving to the left but now when moving to the right it slightly binds on the upper belt still. When I had the belts untensioned the rail freely moved so Im assuming it isnt that. Im not sure if things are slightly misaligned or if ABS parts warped. When this issue popped up I had set a 5 hour print overnight and covered the printer with blankets to reduce noise. Im not sure if possibly the chamber temp got hot enough to warp parts?
9 replies
RRCRat Rig Community [Unofficial]
•Created by Hercules_119 on 4/20/2025 in #fix-my-print
Internal solid infill issue
Sorry I forgot to mark as solved but I ended up turning the temp up and slowing down!
6 replies
RRCRat Rig Community [Unofficial]
•Created by Hercules_119 on 4/29/2025 in #fix-my-printer
Upper belt binding.
For sure I have ceramic bearings ready to drop in but I was waiting for more parts to arrive lol. Thanks though!
9 replies
RRCRat Rig Community [Unofficial]
•Created by Hercules_119 on 4/29/2025 in #fix-my-printer
Upper belt binding.
I do print in an enclosure so I’m not sure if one of the bearings went bad because the heat.
9 replies
RRCRat Rig Community [Unofficial]
•Created by Hercules_119 on 4/29/2025 in #fix-my-printer
Upper belt binding.
Here’s a video of what’s currently happening
9 replies
RRCRat Rig Community [Unofficial]
•Created by Hercules_119 on 4/29/2025 in #fix-my-printer
Upper belt binding.
I should mention I’m moving it by hand. But when moving diagonally so the bottom belt+hybrids it moves freely. But when moving in the x or y direction the top belt binds consistently
9 replies
RRCRat Rig Community [Unofficial]
•Created by Hercules_119 on 3/26/2025 in #fix-my-print
Dialing in ABS Settings
I kinda figured 220 was pretty low but that was in the temp range stated in the spool. I’ll try to print at a higher temp then report back.
4 replies