clutchmasterx1
RRCRat Rig Community [Unofficial]
•Created by Mikey on 5/4/2025 in #fix-my-printer
Major issue with print now printer homes incorrectly in the y axis
If you think it’s a motor driver swap drivers with another one on your board and test again.
5 replies
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 4/11/2025 in #fix-my-print
2 months in, Still no good first layer
Read the Beacon docs from the link and modify your Bed_mesh_calibrate to Probe_Method=Contact
315 replies
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 4/11/2025 in #fix-my-print
2 months in, Still no good first layer
under the Beacon section of your Klipper config set "home_method_when_homed: contact"
315 replies
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 4/11/2025 in #fix-my-print
2 months in, Still no good first layer
315 replies
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 4/11/2025 in #fix-my-print
2 months in, Still no good first layer
You can set it to use proximity (inductive) or contact (accelerometer)
315 replies
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 4/11/2025 in #fix-my-print
2 months in, Still no good first layer
A delta of 2 degrees is fine, Have you tried doing a bed mesh with only beacon contact? The reason I ask is because contact mode uses the onboard accelerometer instead of the inductive probe. It seams like you have done the work to rule out human error I believe it may be a hardware problem. I'm just trying to isolate possibilities.
315 replies
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 4/11/2025 in #fix-my-print
2 months in, Still no good first layer
Get a thermocouple and compare it against the temp measured on the beacon probe. If there is a difference then you have a bad beacon. If the temp delta is large then the prob is not compensating for thermal drift and getting bad reading.
315 replies