Homing sequence kill homing switch
So, this after normal homing.. and the switch gone. Tomorrow RS components send a new one.
Negative temp readings from Octopus V1.1 F446
So, I just bought a VC4 500 Idex, everything was fine, when i plugged in the eletronics fan, after some time, i noticed my Octopus V1.1 F446 was reading negative, and the controller was always active even tho it says 0%.
It's connected to PD12 with 24V jumper....
Solution:
The other one was fried
Pei sheet chipping and peeling vcore 4 500
So ive only had my printer for a couple months now and within a month I started seeing chips in the back corners where it indexes to the pins. But now my build late pei seems to be peeling onto my prints. Mainly pla, asa, petg, pa6 cf, petg cf, pet cf. Any help?
Y linear rails offset or profile twisted
Hello. I have had my V-Core 3.1 Drucker for 3 years. The two linear rails for the Y axis have never run really smoothly since they were first installed. Now I reassembled the printer for the third time new and here's what I saw. If I only attach the 2020 profile to the right joiner plate and move back and forth, the profile remains slightly below the left joiner plate, but is always at the same height. But if I mount it to the left joiner plate, the height on the opposite side changes when movin...
Hotend temp and power osscilating even after pid tune
I recently upgraded to the ratrig toolhead 1.0 on my vcore 3.1 and I PID tuned my hotend at 55% fan speed (I print at 50 normally and 60 for bridges), 215 degrees, and with filament inside. during print the temperature oscillates +- 1 degree and the power oscillates wildly. Is this normal or does this have a fix?
Hotend temp reads 159 degrees at all time, phaetus rapido uhf
So I just updated my vcore 3 to the 1.0 toolhead and I upgraded to ratos 2.1 rc 2 while i was at it, homing and other basic functions work but my hotend is constantly reading 159 degrees +-0.2 degrees. Any ideas?
Solution:
woops, didnt set my thermistor correctly set to pt1000 and fixed
Bed not heating - heater_bed not heating
Hello everyone, my bed was working smoothly. Late night I was burning ASA so my bed was working between 110-105C. I put it to heat and then this message appeared.
I checked other posts and probably it's the thermal fuse. So I have two questions:
1) What are the specs of the thermal fuse, just in case I have to change it?
2) Can I, instead of using a thermal fuse, use a thermal switch? Because if it keeps going off (I plan to work with Nylon a lot) I don't want to keep changing fuses.
...
Rapido 1 Reading Lower Than Expected Temperature
I have a rapido 1. i selected the thermistor in the screenshot. It is reading around 1C when at room temperature. Bed is reading around 16C.
Fan stopping when klipper shows 70%
I'm having issues where the part cooling fan stops completely while klipper shows 70%, I can't figure out what is going wrong.
I'm using orcaslicer 2.2 and latest klipper/ratos.
When I'm not printing I can control the fan perfectly with the slider from mainsail.
Anyone has any ideas? In the slicer preview it never goes to 0% fan....
