Jombo
Jombo
RRCRat Rig Community [Unofficial]
Created by Jombo on 1/25/2025 in #fix-my-resonance
getting strange noise on graph
No description
2 replies
RRCRat Rig Community [Unofficial]
Created by Jombo on 1/23/2025 in #fix-my-printer
Printing Speeds past 150.
I haven't really been able to print anything faster that 150mm/s . I have tried, Elegoo rapid pla +, Elegoo Rapid PETG, Other PETG, Normal Elegoo PLA. The printer is pretty well tuned and my graphs look pretty good. The issue seems to be balancing Temperature, Fans, Speed, Extrusion Multiplier, and Pressure advanced, Retraction and detraction speed and length. It just seems that going faster makes it very inconsistent in how much plastic it is laying down. My filament is feeding from a drying chamber and all my filament is stored and dried before using. I am assuming that I am just butting my head up against the issues everyone has to figure out and balance but I want to ask if i am missing something. I like to make stuff from PETG, ASA or PLA. Is there a better manufacturer of those I should be using? is there maybe something wrong with how i have my feeder tightened or how much friction there is in the PTFE tube that feeds the plastic?
21 replies
RRCRat Rig Community [Unofficial]
Created by Jombo on 1/20/2025 in #ratos-support
issues with vcore 4 500 PEI flex plate
No description
4 replies
RRCRat Rig Community [Unofficial]
Created by Jombo on 1/6/2025 in #fix-my-print
pla vcore4 500 idex
No description
2 replies
RRCRat Rig Community [Unofficial]
Created by Jombo on 12/27/2024 in #fix-my-mesh
when bed is 80c
No description
2 replies
RRCRat Rig Community [Unofficial]
Created by Jombo on 12/25/2024 in #fix-my-printer
RatOS Configuration repository v2.1.x: v2.1.0-RC3-75 > v2.1.0-RC3-82 Invalid
Ok tried to do some upgrades on software. The repository shows invalid. and soft recovery :
Git Repo RatOS: repo not initialized hard recovery : 12:42:27 Error Recovering RatOS 12:42:27 Cannot call rmtree on a symbolic link any ideas how to get it working again?
4 replies
RRCRat Rig Community [Unofficial]
Created by Jombo on 11/28/2024 in #fix-my-printer
Idex fans wont shut up . Part Fan and Toolhead Fan on full
No description
8 replies