JphiLamalice Comments - Answer Overflow

JphiLamalice

•Created by Deska on 3/15/2025 in #fix-my-resonance

big peak on 35hz on y axis help :/

I have found that my screw on the motion system are skew by around 1mm : M5x45 and M5x85 Cap Head Screws. I have ordered new ones. I will test them next week. I will see if it comes from that issue...

9 replies

RRCRat Rig Community [Unofficial]

•Created by Deska on 3/15/2025 in #fix-my-resonance

big peak on 35hz on y axis help :/

Have you figure out the issue for the 35Hz peak?

9 replies

RRCRat Rig Community [Unofficial]

•Created by lingo124 on 4/5/2025 in #fix-my-resonance

Vcore4 IDEX 400 t1_y Resonance Graph Wildly Different

I have the same issue with the low frequency peak 37Hz (a bit lower for the 500 size 32Hz), couldn't find any solution till now...

3 replies

RRCRat Rig Community [Unofficial]

•Created by Mecinios on 5/4/2025 in #fix-my-resonance

Belt tension VCORE4 IDEX 500mm

You need to use Input Shaper for Idex ;). Frequency response is useless

2 replies

RRCRat Rig Community [Unofficial]

•Created by Gian89 on 3/19/2025 in #fix-my-printer

#VAOC cam not recognised

I had my VAOC no longer working... spend one evening to check everything (un-mount, etc)..... to discover this evening that was coming from Firefox web browser.... I have jump to Chrome to test VAOC, with Chrome just in case.... and everything works again... I could re-do my VAOC calibration

4 replies

RRCRat Rig Community [Unofficial]

•Created by N8boy on 2/27/2025 in #fix-my-mesh

V-Core 4 - 300 - What is an acceptable range?

You have to move down a little the back left corner

4 replies

RRCRat Rig Community [Unofficial]

•Created by JphiLamalice on 10/10/2024 in #fix-my-print

PETG bridging issue

This solved my issue, I can continue tuning my printer 😃 I didn't knew about "extrusion rate smoothing" 👍 .. still learning

12 replies

RRCRat Rig Community [Unofficial]