odd z wobble
I don't know if this should go in fix my printer or fix my print...I have an odd z-wobble issue, the z-wobble only happens at the extremes of the x axis and not in the y…sort of. The z axis is belt driven so there is no bent lead screw but there is unmistakeable banding at the same pitch pitch as the gt2 belts used for x,y,z axes. Any idea what might cause this?
Hatchbox pla, 210c, .3 layer, dragon dual switching hotends, .6 Bondtech cht nozzle...
Printer running into negative values due to mesh calculation
Hello, running into this error:
Move out of range: 216.775 20.491 -0.007 [1385.478]
(With alternatig values). The printer does not yet have tilt adjust and a really crappy printbed, which I did not yet have the time to fix....
Steppers refusing to work (first time)
I just got my thermistors wired and steppers, and when I tried to home x or y I get this error, I also attached cfg.
Section 'ratos_homing' is not a valid config section
Just reaching out to see what the fix is for this or if i need to backup my config and start again?
Extruder wiring issues
So in the middle of a print I randomly started to get extruder skipping near a corner of my part. I deduced that this was because the extruder wiring at that part of the printer was either wiggling or loose. Prints work flawlessly when I hold the extruder wire connecter firmly into place in the extruder, and I was wondering how I can fix this issue.
adxl345 wiring and config settings
fresh V Minion build using all stock setting on a SKR2 board.
per the wiring diagram I pinned out the sensor as shown. Getting a FF Vs e5
when I try to check the probe. just not sure if it's a wiring, config or both issue.
...
Strange heating behavior
I'm having a strange heatup pattern on my printer. You can see the dip is a thermal runaway. PID autotuning results in thermal runaway too.
My printer is all self source and my bed is self made so I have a cross drill into the center of the bed so the thermistor gets a reading of the actual bed plate temp. Not sure why it gets stuck at 85 but as soon as you reset and keep heating it follows about the same tangent of the first line.
Does anyone have any idea of what could be causing this behavior?...
