New build right half isn't working, damaged NiceNano?
First of all hello and thanks for reading this 😄 , I just received and assembled my wireless corne, after building it, and flashing the firmware, the left side is working, the right side however is not. I tried to reset them at the same time and to flash the firmware again (multiple times), the troubleshooting guide mentions something about clearning bonds in zmk, but 1. The link doesn't show me how and 2. since I just flashed them / build them from scratch, this shouldn't affect me, right?
I did note that one small silver part was missing on my right side nice nano that was there on the left side, it might have fallen of in shipping, I am attaching photos of that, it says "U3" I think, it is rather tiny.
Are there any additional troubleshooting steps I can perform? If you need any additional information, please just ask....
Problem getting started
Hi, I'm pretty new to all this. I have a 5-column Corne and am trying to use it with a Mac.
Two issues:
1. I can't seem to get the device to appear via Bluetooth. I can get both keyboard halves to appear in the Finder when connected by USB, but no Nano devices appear on Bluetooth. Tried Macbook and iOS.
...
Issues with Flashing
On the hardware side, everything seems fine except for the initial part where i accidentally pushed the no-solder headers into b- and b+ which resulted to the no solder pins popping out. But i popped it back in and reassembled just fine. Everything was flushed, clicked nicely.
However, the problem that i have is due to flashing. I followed joe scotto’s youtube tutorial for that and im fairly comfortable with software. I flashed the left, then right side and was able to connect the board via bluetooth.
Here is the problem:...
