Move out of range at start of print
Hi!
Since yesterday all of a sudden whenever I want to start a print it says "move out of range". This always happens after the primeline. Even with prime line or prime blob deactivated it still happens (after bed mesh, before starting the print).
However when having a look at the exact position where the printer was when this happens and comparing it with where it think it was something is off.
When looking at the toolhead section, the coordinates in the smaller font in grey (exact position) said: x [5,000] y [5,000]...
All files in /config folder are Read-Only
Hi,
since updating everything (Mainsail, Moonraker, Klipper, RatOS) a few days ago, I cannot edit any of the files in my /config folder anymore.
Everything in the main folder (klipper-config) and other folders is perfectly editable. So it's only the /config folder. I had created a few *.cfg files in the
/config folder previous to updating everything. And these files are now also Read-Only.
Does anyone know what could have caused this and if there's a way to fix this ?
I added screenshots of my versions before and after the update....
Sensorless homing
Hey everyone, looking to setup sensor less homing and I get this error? I have tried to reirse the direction on which it homes, but nothing helps.
CB1 board and OV2659 Cam
Can’t seem to get this camera working, I’ve tried a lot of different combinations or ports and index0 and index1.
Someone mentioned I had a space in the wrong place for the by-ID path, I addressed that mistake but still no camera output?...
Horizontal pattern
Hi,
Can someone help me sort this out?
I have ballscrews with wobble rings, bed temp is acurate within 0.3c plus minus...
Massive layer shifts
I started getting layer shifts on my v-core 3.1 and I don't know what's causing it. They're consistently shifting in the same direction and the printer clearly thinks it's still in the right position as when it homes after it goes the same distance to the right and forward.
I reinstalled the os recently with an update to ratos2 when I was having some voltage issues. But the layer shifts continued.
The belts are near perfectly tensioned and I'm not seeing any skipping when they move. Seems to only happen on new layers. ...
The V core500's cable to the extruder hangs down . Any ideas?
V core 500's cable from MCU to Head hangs down.
how are you all solving it?
I'm hanging it from the ceiling now, but this method is not possible at enclosure 2.0....
Extruder heater not heating at expected rate
I've had 1 successful print out of this printer now it's throwing up errors like this about 6-10 layers into a print, is there something I'm doing wrong? I've tried to read the klipper log but all it tells me is that the temperature goes down. Log and screenshot of problem attached.
