Move out of range despite no move out of range in G-Code
There is no move out of range in the G-Code however the printer tries to move out of range. The primeblob had to be adjusted because the printhead is a customized, ultra slim designed:
Inconsistent layers ech every 4mm with belted Z - V-Minion | TicTac Custom
Hi 3d printer owners, I got a weird issue on my custom V-minion printer. Already built belted Z, double mgn12 rails and its moving smoothly by hand. Any suggestion about this?
What I have done:
PID everything several times.....
Board not connecting to my pi.
I attempted to reconfigure my printer after hardware changes. However, the board doesn't automatically flash when accessing the configuration page. I SSHed into the Pi and ran 'lsusb' to check for detection, but found nothing. The board appears powered but lacks LED documentation.
Could it be dead? Or its something else....
Overtemp Error after changing 4028 fan
Hello everyone, today I swapped my 4028 for something useful and as it always goes, the next part glitches when trying it out. Has anyone ever experienced something like this before? I've already swapped the drivers.
The 3 Z-drivers have very different temperatures. One around 35 degrees, one at 55, and one over 60. They are cooled by a 140mm Noctua fan on top of the Octopus. X and Y are each around 30. When the print starts, it stops with this message. This only happens in performance mode since i changed the 4028... Does anyone have an idea?...
Ceramic heater not feeding filament through
Filament is able to feed through until it hits the post of the ceramic heater, it was working fine before but not anymore, it just jams, and the bondtech extruder clicks even when using “load_filament” (temp rises to 220 but just keeps clicking bond extruder.
The ceramic heater rod seems to no longer be compatible with the 1.75mm diameter prusament PETG filament that was going through the system and printing before (although the prints were filled with bubbling from above the nozzle so assuming the system wasn’t tight before, tightening now have this problem although I can’t see how it’s related)...
X Endstop Always Triggered
I'm having an issue where my x endstop is always showing as triggered in Klipper. The endstop light turns on when pressed, but seems not to register the input.
I'm following this ↓ wiring diagram for the octopus.
I've replaced the wire because I thought the the other one was getting hot - and, because I had to flip the wire. With the new wire (pictured) I still can't get it to work, so I can't tell if it's a hardware or software issue.
Thanks for any input, I really appreciate it....
Thermistor start read at 158C, when start to heat, the read decreases
We have finished to assemble the Vcore 3 500mm, everything is running ok, but
it reads direct on hotend thermistor 158ºc, when on the temperature starts to raise, the reading is inverted, is any issue on Config, or is defective thermistor.
when it drops 20c instead of increasing, safe shutsdown...
Solution:
add
to your printer.cfg under User Overrides...
RR 500 - Commissioning - Perimeter wobble above 80mm/s
Hi all,
Losing my hair over this. Rat Rig 500 with carbon gantry and MGN9H. Hemera XS Extruder with Obxidian hardened nozzle printing CF-PETG and PETG.
Battling a VFA-resonances and have currently:...
