Unpredictable layer shift on brand New Vcore
Hi ! This freshly built vcore 300 is displaying some weird, inconsistent layer shift all the way through the print.
I checked the Z coupler and X/Y pulley, tensioned the belt.
The printer moves fine, feel fine, extrude fine and the part is solid but its useless. ...
Delta Fan not turning off at 0%.
I have installed a delta fan today, and the fan will not shut off when its indicating 0% in the dashboard. I have everything connected to the octopus 1.1 pro board like in the screenshot attached. I also included the following to printer.cfg:
[fan]
pin: !fan_part_cooling_pin
cycle_time: 0.01...
Octo board not behaving correctly
I'm trying to set up a VCore 3 but I was having a belt issue which I got fixed, but now the Octo board is doing weird things. Its showing 4 new green lights that I haven't seen before, is outputting power to the hotend when I plug it into the power outlet, isn't powering the raspberry pi, and crashes RatOS when the raspberry pi is independently powered with a 500 internal server error. I thought reflashing the board might fix it but I'm having trouble with that as well. Should I get a new board,...
FIXed: Section 'ratos_homing' is not a valid config section
So today I started my VC 3.1 300 and had several Repo is corrupt errors in the machine section, RatOS, Klipper, Moonraker and RatOS Theme were affected.
A hard reset on those repos seemed to fix it, however after rebooting the pi I get the error:
Section 'ratos_homing' is not a valid config sectionWell I just found the fix and thought I'll still post for future reference:...
Weird error messages
I keep getting this error message. Can someone help? I think these messages pop up thousands of times during a print. See photo for error.
Cracked heater or...
Hi, so I recently made a print, had a little clogged of filament. Either the temp for material was high or I did jot force the nozzle enough.
Cleaned everything up. Heated the heater, changed the nozzle to a new one, made sure everything was clean, tightened up.
Cooled down, added the sock....
Solution:
It's either the thermistor not reading to, or the heater not heating up. Either way I don't know if those are replaceable on the rapidos. Worth looking up
Hotend Heater going too high?
Not sure if anything is going wrong, have rapido 1.0 hotend with 104 thermistor. I was printing PLA and was going to go back to ABS, but I noticed it was crackling and smoking a lot. I checked the temperature with a camera and it was almost 300 C when it was set to 250 C and was reading as 250 C. Seems odd as it is working at 220 C correctly.
Trouble with printer.cfg after IS calibration
Hey folks. I did the IS calibration as told in ther comissioning guide, but after I added the code in the user.override section, klipper just reports an error upon every startup. If I remove everything from the section ittl work, but once I add event he code thats been in there before it wont. Screenshot and cfg file attached. Thanks for every little help.
z-tilt problem
hi i have a 500 v core. printing perfect until january. Yesterday i updated the machine. without problems.
When i restarted the machine. i start the problem with z-tilt.
looking for a solution in the discord, i found, that the problem can be a mechanical problem. i check all the extruder, but all is fixed and tight.
...
