[solved] Extremely long wait after prime blob
My printer stops at position shown in image when starting a print after prime blob. Hotend temperature is moving up and down 1 degree above or lower than set temperature. I have changed thermistor and I have done PID tuning.
the gates belt sliding down
The belt is sliding down all the time on the left front of the 3dprinter. The belt is tight
Nasty hot end collision and now I'm getting this on my bed meshes.
Afternoon, I had a nasty print collision which broke my rapido 2. I have replaced that and done a once over on the printer. Now when I do my mesh bed leveling I get what you see in the picture. I checked with paper and it is actually 1.2mm higher at the back of the bed than the front. I assume the collision was so hard it tweaked my frame? Not sure how to adjust this. Any info or tips very welcome.
BTT Smart Sensor Pauses after Prime Blob, Doesn't detect during print.
I installed a BTT smart filament sensor V1 (SFS) and when I start a print during the prime blob it goes from "active" to "empty" in mainsail and pauses the print immediately.
Then to be sure, I snipped the filament before it went in and it didn't detect the runout.
I put the macro in the user overides config but I might have missed something somewhere. Appreciate any help. Config included....
bondtech lgx lite skipps
hey i have a bondtech lgx and it seams to skip on the filament like im pushing it. anyone have any ideas what might be going wrong 😭 it uses the Duet 3 Mini 5+ but im worried the wires are messed up couldn't find definitive way to wire up the motor
V-Minion Y-axis slipping
Howdy,
My V-Minion's Y axis is slipping if I push acceleration anywhere north of 5k mm/s^2. I really don't know what could be causing this. I am using a BTT SKR2 with TMC2209 stepper drivers and the stock V-Minion LDO steppers. I tried putting it on top of a 35lb concrete paver and making sure the steppers were configured for active cooling. Any help would be greatly appreciated....
