Big Layer Shifts
Been having an issue where my prints will be split partway through. I have not directly observed this in person. It started appearing shortly after I increased the velocity of non print moves from 250 to 500 (but not immediately after that change). It does not happen every print
When it happens, it seems like the x and y position will be wrong. Cancelling the print will cause the head to try and move out of bounds
I don't know what direction to look into fixing this besides lowering the non print speed again (which was done to avoid blobs on surfaces)...
Tightening xy joiners makes rails not smooth
Hi,
After deciding to square my frame a realized that when I tighten xy joiners the x rail is not smooth anymore, can someone help me with some guidance about how to check what is wrong?
Frame is square, all rails are new.
Thanks!...
[Solved] New 500 build. immediately clogs
I’m in the process of commissioning a 500 and I got to the spot to print my first layer. (PLA)
The head blobs ok I guess and then never lays down a clean line.
I can clear it and have it extrude in the air but it clogs on every attempt. I’ve tried increasing the temp but it does the same thing. ...
Resolved-Enclosure shelf parts don’t fit
First RR build. 500. Printed the enclosure top shelf parts right and left. They don’t seem to align with the umbilical strain relief part. Also doesn’t seem to be a hole for that part either. I’m probably doing something wrong. Any advice is much appreciated. ✌️
probe triggered prior to movement
My nozzle was clogged.... had to remove it completely and clean. After I reinstalled it, I first reset the z-offset (probe_calibrate). When I then wanted to start printing, it only threw the error probe triggered Prior to movement at the fifth checkpoint when calibrating the print bed.
Checked the cables, set z-offset again and found no error anywhere. Tried the whole thing again with the bed_mesh_calibrate command. There it threw the same error only at the second checkpoint (see picture).
Where is the error?...
Difficulty getting the frame aligned
I'm having extreme difficulty getting two corners square. I've already tried everything. do you have any tips?
