Issue with bed leveling
I'm running into issues where I'll print something large and in one corner it prints fine but the other the nozzle gets way to close, I run a true bed level before every print but not sure how to fix this
Klipper reports SHUTDOWN
i am tried all the way servals times , even i bought skr2 board and 5 new SD cards , but always same results , in the step that i install v minion i get this result
can any one help me please , and if there something to do with config , can i get any link that help me step by step , regards đ #fix-my-printer...
I think I just opened Pandoras Box, TRIED TO UPDATE
Hello, this is the first time I tried to do updates an my V Core 500. i just clicked sequentially all updates and now this 
(SOLVED) V-Minion error âPrint exceeds max extrusionâ
Iâm getting this error, have been printing this very same with no problems, now I canât start a new print anymoreâŚdid not change any of the original setting re measures of printer.
Have tried Cura and SuperSlicer, both throw the same errorâŚany idea on what to check?...
EBB42 ADXL not working
when doing a query i get the error message as shown in the screenshot.
my printer.cfg is correct (i guess), declared the toolboard ADXL
the toolboard works, extruder, hotend, endstop, both fans. (still need to wire the probe)
i even compared the pins declared vs the EBB42 schematic....................
Best way to route filament with Enclosure 2.0?
Over the holidays I finally got around to building the Enclosure 2.0 for my VC400. I made my own panels and mounted them knowing I still had a lot of design work on figuring out the routing of the filament and the mounting of my Klipper display.
I did not like the Ratrig method of routing the filament thru the back. I figured the inside mounting worked with Enclosure 1.0, so why not that....
V-core3 overheats after homing in 2 minutes and shuts down
Hey everyone. I just finished my V-core3 and yeah the above mentioned problem occurs(see Screnshot attached for the fault). I noticed, that the drivers were getting really really hot quickly just when the printer is homed and sitting there, no active movement. I swapped the three z-axis drivers for the ones I had in my v-minion and the problem was fixed. The drivers are both 2209s but the ones that shipped with the vcore3 where v1.3 while the ones from the v-minion where v1.2(see pictures). Does anyone know what is causing the problem here? Sense resistor is the same on both and they are both 2209 drivers from BTT.
Thanks a lot for your input!...
(SOLVED) SKR 2 Fan2 incorrect socket?
Hiya all, building my v-Minion from a full kit via Fabreeko.
Ran across an odd issue. My SKR 2 board Fan2 socket (which is used for the electronics enclosure fan) seems to be switched around.
Board pin out says 1st pin is VBB (+) and 2nd is PB5 (-). Wiring diagram shows fan should be plugged in with pin 1 - red wire, pin 2 - black wire.
...
Help - Stepper Issues
Finally got around to building my V-Core 3 with Oldham Z system from BRS.
Crazy long build but I believe all square and I think I did IMO, a very good job on wiring.
Setup is BTT Octopus 1.1 407 version with 2209 steppers.
U2C Can board with EBB42 - this took time but all working great now....
