extruder not heating correctly "verify_heater" issue where it sits at 150 C
Hi All, I'm having an issue trying to set up my extruder. I get the issue shown in the first image, other people have had the issue but with slightly different solutions.
I see others have had a thermistor/sensor setup issue in their config files, however i didn't have the sensor heading in my config file, it looked like what is shown in the second image. with nozzle diameter dir_pin, control, pid_kp etc.
After seeing other peoples config setups that included sensor type etc. I went and found the rapido (my hotend) .cfg file, which had all the info I was missing and copied the info from this (see third image) and added it into my config file where all the dir_pin, control, pid_kp etc. was that other people didn't have....
Solution:
that looks like its worked thankyou!!!!!!
Belt issues
So I have two issues going on with my upper belt that I am going to replace. The first is I am getting some rubbing on the top of the belt near the motor/idler near the motor that I believe is rubbing on the idler as I have already adjusted the pulley on the motor. What are my options for trying to fix it other than disasembling the printer and trying to re-square the frame? Could I fit a space under the bearing stack to move it up? The second is that I have a spot on the belt that is almost wor...
Bad First Layer Outside of Probed Area
Basically always getting bad first layer on the right side of the plate where the probe can't reach. I don't know what Klipper does, if it guesses what the area is like past the probed max area, or what. What it is doing is moving the nozzle too far away so the last 3cm on the entire right side is always bad.
The klipper settings for bed mesh and documentation don't make mention of what it does for the area. I've squared the frame the best I can, the 3 points that are probed are within 0.02mm of each other, the bed just isn't the greatest I guess but usually the heightmap is less than 0.17mm tolerance....
Need link to eva extruder files
I have a ratrig Vcore 3 (not upgraded to 3.1), and the cooling ducts snapped off during a bad print fail. I've tried looking for where the print files are hosted without much success.
Can someone please me a pointer on where to download the part I need? Thanks....
Y Stepper motor only move one direction
Hi,
I just got a Rat Rig V-core 3.1 standard kit. I am having a problem where the Y stepper motor only moves in one direction. When the axes are jogged using the interface the printer only moves towards negative Y and Positive X. The attached pictures show the input given and how the printer moves in response.
What I have tried for troubleshooting:...
Solution:
something like this
https://discord.com/channels/582187371529764864/1179811532276764752/1179832323764670495...
Problems Configuring WebCam
Hello everyone,
I recently decided to reflash my Raspberry Pi 3+ B from scratch, opting for a fresh install of RatOS-v2.0.2. The installation process went quite smoothly until I encountered an issue with setting up the camera. I've configured the camera as a webcam/webrtc, and when I check with
lsusb, it confirms that the camera is indeed detected.
However, I'm facing challenges at this stage and could use some guidance. Here are the steps I've taken so far, specific to my Raspberry Pi setup:...
MCU protocol error on Octo pro 429
MCU protocol error on Octo pro 429
I dont know if its something specific to the Octo Pro 429 or me just being dumb/new. Performed an update now getting this error. Tried flahing the firmware as instructed in several links found by google search but still no luck. Octo Pro 429 + Pi 4 B on a Vcore 300 running Ratos 2.0.2.
Any help?...
