manta m8p poblem speed
hi everyone.., today I transformed the x y steppers into 48v and put an m8p manta but when I homing for example X, I see the gantry move slightly in Y…. how is it possible? first with the octopus and 24v I don't think it did it... then if I did a speed test first at 24v before it went into error I reached 17000 acceleration and 700 speed... now at 600 speed it gives an error even at 5000 acceleration… then I tried a gcode from the speedy benchy that I used in 24v, and now after a while the mcu g...
Crooked Gantry, Bad IS (Solved)
Hello, I recently upgraded and as part of my diagnosis of some IS issues, I noticed how crooked my gantry is. While I had previously corrected this by tensioning the belt. I have noticed that my belt tension graph did not appear to be changing. I loosened all the fasteners on the y gantry blocks, the belts are slack, but it is still crooked. The left y carriage with its blocks loosened does not mate against the endstop.
My understanding of the guide is that I am to pretension the belt then screw the gantry plate back into place, and this is what I had done. But is this just covering up the issue? The carriages slide smoothly, which suggests to me that the issue is not a misalignment of the rails....
MCU 'mcu' shutdown: ADC out of range
I recently had to change my hot end assembly on my enclosed V-core 3.1 after about 1000h of it working pretty well. After installing the new hot end I was able to print for another 10h until it crashed with the following message "MCU 'mcu' shutdown: ADC out of range". I found out that the thermistor connector was not properly connected so I changed it to make sure it wouldn't happen again, and now the connection is good but that error remains and I have no clue where it come from.
pt1000 rapido uhf 2 plus
I connect the rapido uhf 2 plus on my btt octopus v1.1, i edited the printer.cfg and selected rapido and also i went at the end of the list and typed:
[extruder]
sensor_type: PT1000
still not working...
No power to the heaters: rough love story with my Octopus board
In previous episodes:
1. I bought a full kit V-core 3.1. (400) and successfully got to the PID tests as per online comissioning guide.
2. Both PID tests failed with "not heating fast enough" errors both on hotend and heat bed.
3. Using hair dryer and independent power sources, I confirmed beyond doubt that both thermistors and heaters work properly.
4. Using multimeter and changing pin assignment, I confirmed that the whole 24V section (PA1-3 & PB10-11) is dead to the world....
ADXL345 calculation not returning any info.
When I use SHAPER_CALIBRATE AXIS=X, doesn't return the calculation for the input shaping. Does anyone know why?
The ADXL345 is connected to Octopus
Printer specs: v-minion, Pi 3 Model A+, BTT octopus 1.1.
...
Print Bed PRoblems Part2
Hi after I have now unclogged x and y which I did once with a cold and once with a warm printer I have to realize that after 2 cooling cycles overnight it starts to suck again. The cold decompression had only made the whole thing worse. Preventively decompressing with a warm enc had top results with the first print. Now after 2 overnight cooling cycles it starts to go to shit again. So the printer turns out to be more and more a piece of junk for what I do with it. I have insulated the enc and f...
