can’t upload gcodes to my vcore3
Is is all that pulls up and I am unable to connect via laptop never have been able to always used my phone now after letting it sit idle for a couple weeks I can’t upload anything
Bed Mesh Issues for 500mm V-core
@beany As mentioned before the head is nearly colliding with the bed and I'm unsure what the issue may be. The mesh is indeed correct from what I've seen with the larger prints, so I'm thinking this could be mechanical or software related.
touch screen help v minion
Hey guys
My v-minion has been solid over the past 2 weeks I’ve had it
Been using it through the url. Would like to get screen working
...
"Unable to read Tmc uart" stepper_z1"
Hi everyone. I have just finished building my vcore 3.1. I have changed my build slightly and purchased a manta m8p since my raspberry pi is tied up to a work project. I knew from searching around, there wasn't much trouble shooting or help using this board with ratos. I've got 3 printers running klipper already, all using skr mini boards. I thought id risk it, hoping everything would be good if I followed instructions to the letter. I guess not.
First, I mounted everything and made up my power leads. My first test, try the heaters, all good. Second test, wire in probe, fans and Endstop. All good apart from the part cooling fan (I'll make a separate post for this).
Lastly, I went for my motors....
software bedmesh doesn’t seem to translate to physical bed
Basically I have my the current bed mesh that’s with 0.2 variance. The middle dip seems to be more of a bed problem. I have tightened and retightened X gantry and y rails but always end up with this shape.
Nevertheless it’s an acceptable variance. However the low areas are to far from the nozzle and the upper areas are too high. So it seems my physical bed is not properly moving up and down according to the bed mesh.
Am thinking not enough z torque or lube to the z rods? My steppers are uncooled so using the uncooled configs for the steppers if that makes a difference....
