Heater heater_bed not heating at expected rate See the 'verify_heater'
I received this error after attempting to raise my bed temp to greater than 145C. It seems that the thermistor is working fine, as the temper gradually dropped after getting the error. I plugged the 110v Keenovo bed heater directly into 110v and it is not warming at all.
I'm not familiar with these bed heaters? Is there some part of it that needs replaced... or the whole thing? ...or am I wholesale diagnosing this issue incorrectly?...
issues pt1000 rapido 2
Got issues with new rapido 2 plus..
Temp shows hotter than the sun 30mil+ degrees C..
New hotend.. new sensor (but COULD be broken).. also changed the cable from board (octopus 1.1 557) and directly plugged it in.. everything same..
...
Bed is not being supplied power
My C-LIN relay (Default Relay for v-core 3.1) has a red light and is being supplied 24v dc power but is not supplying any ac power. (Checked with a multimeter)
This means my bed is not heating up. Any thoughts on how to fix this issue?...
New vcore Estopping on Startup
I'm having a problem where my 3D printer is estopping. I'm pretty sure the problem is because of this but I'm not sure how to fix it:
[idle_timeout]
gcode =
{% if printer.webhooks.state|lower == 'ready' %}
{% if printer.pause_resume.is_paused|lower == 'false' %}...
Pi CAM does not work
Hi guys, as I updated mainsail, the pi cam does not work any more. Trying to fix I got the info you can see in the jpg attached. What can I do?
XY motor plates not fitting well
The heads of the m5x40 screws are not entering the printed part for me like shown in the picture for the build guide. I saw this comment about removing the printed motor mount attached to the aluminum motor plate. If I remove the printed part would that mess anything up?
Problems with Octopus Pro H723 V1.1
Hello im setting up a V-Core 3.1 with a Octopus Pro H723 V1.1 and an Ebb36 V1.2 but when i use the Setup Wizard this pops up after flashing the board.
MCU Update error
Hello. Today me and my son bought 2 used V-minions.
I´ve got one of them up and running and was able to control it and start a print.
After i Updated everything i get MCU errors.
I have no idea how to update the MCU. Can someone lead me in the right direction....
My z-tilt seems skewed
When my machine (vc500) probes the bed, it seems like the probe is coming down a little bit to the right. Is this normal?
In the picture, the green is what is expected. The red is what is actually happening....
