Tightening belts causes y-rail noise Vcore3
Has anyone had this happen?
After getting my deracking fully sorted with belts off, and the y-rail sliding nicely even with some inertia, I tighten up the belts and now its movement in Y is clunk clunk clunk clunk.
Movement in the X doesn't have this problem, therefore limiting the variables to the Y rail bearings.
Any thoughts?...
Help! I am loosing my mind over the ugly layer issue. V-Minion.
Hopefully someone can help here.
I am one of the few here who has issues with the V-Minion putting out quite some ugly layers.
But in spite of many others here I somehow can not get it fixed.
Here is a picture of what print results I get....
'RatOS invalid' in update-tab
Hi!
I wanted to update RatOS along klipper and moonraker a few months ago and it said 'RatOS' invalid in red color. When trying to soft or hard-recover RatOS it fails with the error 'fatal loose error', see picture. I told this problem here along another problem I had at this time so someone suggested my sd card was broken. However the SD card turned out to be fine so I decided to wait but nothing changed yet. I contacted RatRig regarding this issue and they told me to ask here. So here I am... I hope somebody can tell me what to do as I really want to update it further and ain't much of a software guy...
Greetings,
Vince...
configuration
need help to set up configuration for ratrig v3 size 400 got lost to understand the guide
i already installed klipper on board oct v1.1
already installed ratos on pi and installed vcore three config
connected to my pc going to machine removeed # on printer.cfg to what i have and now got lost how to do the next step .. i got error ( control _pin in section bltouch must be specified !! . what the next steps
notice my knowledge almost basic on klipper...
Belt Erosion
Hey all, I was disassembling my Vcore 3.1 500 and found that the belts had been pretty horribly eroded. See pictures. What do you think could cause this? I am guessing the belts were way too tight.
occasional layer shift / Belt shifting
As you can see, can happen in the mide of the print. Very annoying.
Pulleys are tigthened firmly.
Where else can I check ?...
wired print artifacts
I've upgraded my rr500 to v3.1, since then I get this wired artifacts, normally a clear indicator of under extrusion but it's not. What I did so far:
1. Changed settings like acceleration, print speed etc.
2. Checked everything on the extrusin side, checked configs again and again, wiring, it extrudes what it should Extrude, no skipped steps or similar
3. Changed from orbiter 2.0 back to 1.5 with no difference...
Issues with SAVE_CONFIG
Not sure why, but when I enter a SAVE_CONFIG command I get the following.. any idea what could be causing this?
