fix my Bed!
Help! I’ve removed my heatbed replaced some parts and placed it back now my mesh is screwed…
It’s about a V-Minion...
Deep Resonance
I have recently built my vcore 3.1 500 and I am having an issue with very pronounced ghosting on the X axis. Deep enough to feel. The Y axis is mostly fine.
Tightening the belts past (what I think) is too tight does not fix it. And at this point loosening the belts does not impact it. I have just done a check and did not find any loose nuts or bolts. I do not believe the belt is rubbing against the printed parts.
I do not yet have an ADXL345....
Hotend and Bed Temp Issues?
Hi all,
As shown in the picture below i keep getting this issue on my prints. It starts printing just fine on the first dozen or so layers, and then as soon as i walk away and come back i return to this. The extruder is gently clicking and whisps and hairs are coming out. This has happened 5 times in a row.
I think the issue is that the hotend is not actually as hot as the firmware thinks, which is supposed to be between 215C-220C. Also after heating the bed plate for about 20 mins it reads 55°C rather than the 60°C asked for. (Laser thermometer test)...
Carriage slowly drifting to rear left
I thought I'd fixed my problems and then new ones showed up.
So I managed to get a decent benchy printed at last, then a friend recommended I switch nozzles back to a 0.4 for the initial tests. I did and after some fiddling with the bltouch probe I got it back in working order.
Then as I went to do a first layer print, the carriage scraped the bed and after that I've been noticing the carriage has been slowly drifting to the rear left of the printer whenever it moves diagonally to the front right. When it did the initial bed levelling, it drifted further until the bltouch was off the bed and it collided with the carriage....
Over temperature TMC2209 error even with replacement TMC2209
got a GSTAT error the other day. So swapped to higher flow fans on my BTT Octopus Pro 446. Ran two big prints without a problem.
Last night, than again today got over temp errors again from stepper_y. IR temp sensor says yes, stepper driver _Y was definitely hotter than the rest (~55°C diff others at ~35°C... yes cooled a bit after shut-down after the error state that stopped the print) Checking the motors, Y was actually cooler to the touch than X. So examined the wiring. No detectable issues when ohm-ing them and jerking the connectors around (no opens or shorts). Same for the motors themselves. (ohming)
the error didn't appear to show up in klipper.log (see attached)
This is stock RatOS (not 2.0) high perf stepper configs, BTT TMC2209s with the larger heat sinks. I'd already backed down the motor currents to 1.5A well before ever getting this error.
...
Bed temperature not stable (Keenovo 157 220V 600W)
Hi all,
After installation and initial setup of my 300 size V3.1, I notice the following in the temperature graph. The hot-end thermocouple is stable as a rock, but the bed thermocouple (integrated in the silicone heater) is very unstable. It seems to go up and down by about 2 degrees (18 - 20 C range in this image). The signal change is slow (thus low-frequency) and happens while the bed it not heated.
I switched the TC to a different input, the same thing happens....
